PA - Spark Timing Check -- Distributor Ignition

NOTE: Before proceeding with this Pinpoint Test, verify that the base timing check has been performed.

- Key "OFF".

- Disconnect Powertrain Control Module (PCM). Inspect for damaged or pushed out pins, corrosion, loose wires, etc. Service as necessary.

- Install breakout box, leave PCM disconnected.

- Key "ON", engine "OFF".

- Measure voltage between test pin 37 and test pin 40 at the breakout box.

- Measure voltage between test pin 57 and test pin 60 at the breakout box.

- Is each voltage greater than 10.5 volts?

Yes -- Go to PA2.

No -- Go to pinpoint test step X1. X - Constant Control Relay Module (CCRM)