Quick Test 2.0 - Set Up

Connect Rotunda New Generation Star (NGS) Tester 007-00500 or equivalent to Data Link Connector (DLC).

The following are procedures to run OBD II procedures.
Prepare the vehicle as follows:
- Put transaxle range selector lever in PARK.
- Warm engine to operating temperature.
- Apply parking brake.
- Block wheels.
- Turn off all electrical loads including A/C and defroster. (If A/C is on, DTC P1460 will set.)





Prepare the NGS as follows:
- Turn ignition switch to the OFF position.
- Verify that the proper PROGRAM card is inserted in the NGS.
- Connect J1962/ 16 way data communications link (DLC) cable adapter to the NGS.
- Connect NGS DLC cable adapter securely into the vehicle s data link connector (DLC). Connect the NGS power supply cable to the vehicle battery power supply through cigar lighter or at the battery with alligator clip adapter.
- Turn the ignition switch to the RUN position, or start vehicle if necessary.
- The NGS is now ready to communicate with the Powertrain control module.