Camber

1. Camber adjustments are provided for by shims on the upper control arm. Shims are to be added, subtracted or switched from the front and rear legs, as necessary, to achieve desired settings.
2. To adjust camber, remove or add an equal number of shims to the front and rear legs of the control arm.

Fig. 1 Caster/Camber Variation Chart:

NOTE: If an unequal number of shims is added or subtracted to the front or rear legs of the upper control arm, both caster and camber settings will be revised. Refer to the Caster/Camber Variation Chart, when adjusting camber and caster to specification.