Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 1996 >> Contour L4-122 2.0L DOHC VIN 3 SFI >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Throttle Position Sensor >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Throttle Position Sensor: Service and Repair

REMOVAL
1. Disconnect battery ground cable.

NOTE: When the battery has been disconnected and reconnected, some abnormal drive symptoms may occur while the Powertrain Control Module (PCM) relearns its adaptive strategy. The vehicle may need to be driven 16 km (10 miles) or more to relearn the strategy.

2. Remove the engine air intake resonator from throttle body.
3. Disconnect fuel charging wiring from Throttle Position (TP) sensor.
4. Remove two TP sensor retaining screws.
5. Remove TP sensor.

INSTALLATION

CAUTION: Slide rotary tangs into position over throttle shaft blade, then rotate TP sensor clockwise to installed position only. Failure to install the TP sensor in this manner may result in possible damage to the sensor or excessive idle speeds.

1. Install TP sensor. Ensure that rotary tangs on sensor are in proper alignment.

NOTE: TP sensor is not adjustable.

2. Secure TP sensor to throttle body with two retaining screws. Tighten to 2.8-3.8 Nm (25-34 lb in).
3. Connect fuel charging wiring to TP sensor.
4. Install the engine air intake resonator to the throttle body.
5. Connect battery ground cable.
pro multis · About Operation CHARM