Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 1996 >> Explorer 4WD V8-302 5.0L >> Repair and Diagnosis >> Powertrain Management >> Ignition System >> Ignition Coil >> Service and Repair >> Ignition Coil Pack
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Coil Pack




REMOVAL
1. Disconnect engine control sensor wiring from ignition coils and radio ignition interference capacitors.
2. Disconnect ignition wires by squeezing locking tabs and twisting while pulling upward.
3. Remove four ignition coil retaining screws and remove ignition coils and radio ignition interference capacitors. Save radio ignition interference capacitors for reinstallation with ignition coils.

INSTALLATION
1. Position ignition coils and radio ignition interference capacitors to mounting bracket.
2. Install ignition coil retaining screws and tighten to 5-7 N.m (44-61 lb in).
3. Apply Silicone Dielectric Compound to all ignition wire spark plug boots.
4. Install each ignition wire connector to the proper terminal on the ignition coil. Make sure boots are fully seated.
5. Connect the engine control sensor wiring to the ignition coils and radio ignition interference capacitors.
pro multis · About Operation CHARM