Shift Interlock Solenoid: Service and Repair

1. Remove lefthand lower instrument panel trim and steering column lower shroud.
2. Remove steering column retaining nuts, then lower column to floor.
3. Remove cable retaining clip, then disconnect electrical connector at actuator.
4. Remove actuator retaining screws, then actuator from steering column.
5. Reverse procedure to install. Torque steering column retaining nuts to 15-24 ft lb and cable retaining screws at steering column and at shifter to 10-13 in lb.
6. Test cable for proper operation, ignition key should only be removable with shift lever in PARK. Shifter should be locked in PARK with ignition key removed, or with key in ON position and brake not applied. Shifter should release when brakes are applied.