Operation CHARM: Car repair manuals for everyone.
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

Ignition Coil Pack

Ignition Coil:




REMOVAL
1. Disconnect fuel charging wiring electrical connectors from ignition coil and radio ignition interference capacitor.

CAUTION: Do not pull on the spark plug wire as it may separate from the spark plug wire connector inside the spark plug wire boot.

2. Disconnect spark plug wires by squeezing locking tabs and twisting while pulling upward.
3. Remove two ignition coil nuts and top ignition coil mounting bracket nut. Remove ignition coil and radio and ignition interference capacitor for installation with the new ignition coil.
4. Remove Exhaust Gas Recirculation (EGR) vacuum regulator solenoid nuts and remove EGR vacuum regulator solenoid.


INSTALLATION
1. Position the EGR vacuum regulator solenoid and install the nuts. Install EGR vacuum regulator bracket nut. Tighten EGR vacuum regulator solenoid nuts to 8-12 N.m (6-8 lb ft).
2. Position ignition coil and radio ignition interference capacitor to ignition coil mounting bracket.
3. Install two ignition coil nuts and top ignition coil mounting bracket nut. Tighten to 16-20 N.m (12-14 lb ft).
4. Apply Silicone Brake Caliper Grease and Dielectric Compound to all spark plug wire boots.
5. Install each spark plug wire connector to the proper terminal on the ignition coil. Make sure spark plug wire boots are fully seated.
6. Connect ignition coil and radio ignition interference capacitor electrical connectors.