Throttle Position Sensor: Service and Repair

Throttle Body Assembly:

REMOVAL
1. Disconnect Throttle Position (TP) sensor electrical connector engine control sensor wiring.
2. Remove the two throttle position sensor retaining screws.
3. Remove the throttle position sensor and throttle position sensor gasket.

INSTALLATION
1. Position the throttle position sensor on the throttle body. Make sure that rotary tangs on sensor are in proper alignment with the throttle shaft blade.

NOTE: This throttle position sensor is non-adjustable.


2. Secure throttle position sensor to throttle body with two retaining screws. Tighten to 3-4 Nm (28-35 lb in).
3. Connect electrical connector to the throttle position sensor.