Audible Warning Device Control Module: Service and Repair

REMOVAL






The Generic Electronic Module (GEM) is connected to the rear of the fuse junction panel.

1. Disconnect battery ground cable.
2. Remove two nuts retaining fuse junction panel to dash panel.
3. Pull upper ears of fuse junction panel down out of retaining bracket.
4. Disengage locking tangs and disconnect three harness connectors from bottom of Generic Electronic Module (GEM).
5. Turn fuse junction panel over and remove screw retaining Generic Electronic Module (GEM) to fuse junction panel.
6. Disconnect and remove Generic Electronic Module (GEM) from fuse junction panel.

INSTALLATION
1. To install, reverse Removal procedure.
2. Tighten Generic Electronic Module (GEM) retaining screw to 1-2 Nm (9-18 lb-in). Tighten retaining nuts to 4-6 Nm (35-53 lb-in).