Starter Motor: Service and Repair

WARNING: When servicing the starter motor, note that the heavy gauge input lead connected to the starter solenoid is hot at all times. Ensure the protective cap is installed over the terminal and is replaced after service.

1. Disconnect battery ground cable.
2. Raise and support vehicle.
3. Disconnect engine control sensor wiring and starter battery cable from starter solenoid.

NOTE: When disconnecting hard-shell connector of engine control sensor wiring at S-terminal, grasp the plastic shell and pull straight off. Do not pull on wire. Replace any part of the connector that is damaged during removal.

4. Remove upper and lower starter attaching bolts, then the starter motor.
5. Reverse procedure to install, noting the following:
a. Torque upper and lower attaching bolts to 16-21 ft lb.
b. Torque starter battery cable to solenoid nut to 7-10 ft lb.