Installation

1. Position steering column on floor of vehicle.
2. Push shift cable retainer into slot on bracket and snap shift cable end onto shaft of transmission selector lever arm and support lever arm.





3. Insert steering gear input worm gear and rack into universal joint, making sure cutout in steering gear input worm gear and rack aligns with universal joint pinch bolt hole.
4. Raise steering column into position onto instrument panel reinforcement studs.
5. Install four nuts securing steering column to instrument panel reinforcement. Tighten to 13-17 Nm (112-153 inch lbs.).
6. Install steering column absorber and four nuts. Tighten nuts to 23-32 Nm (18-23 ft. lbs.).
7. Install universal joint pinch bolt. Tighten to 40-54 Nm (30-40 ft. lbs.).
8. Install transmission range indicator. Connect cable loop to transmission column shift selector tube.
9. Connect main wiring harness to steering column electrical connectors. Connect shift lock actuator.
10. Install instrument panel steering column opening brace.
11. Install instrument panel steering column cover reinforcement and tighten screws to 10-14 Nm (88-123 inch lbs.).
12. Install instrument panel steering column cover and tighten screws to 10-14 Nm (88-123 inch lbs.).
13. Install steering wheel.