Alignment Shims

ALIGNMENT SHIMS

REMOVAL
1. Raise the vehicle and remove the wheel and tire.
2. Remove the upper ball joint camber adjuster clamp bolt and nut. Remove the clamp from axle.
3. Remove the camber adjuster from the axle. Using Ball Joint Removing Tool D81T-3010-B or equivalent, wedge the adjuster out of the axle.

INSTALLATION
1. Install the correct camber adjuster into the axle, aligning the slot in the adjuster.
2. Install the adjuster on the upper ball joint stud and tap the adjuster into the axle.
3. Install the clamp bolt and nut in the axle. Tighten the nut to 68-92 Nm (50-68 ft. lbs.).
4. Install the wheel and tire. Lower the vehicle.