Removal and Installation

CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

REMOVAL
1. Disconnect the battery ground cable.
2. Remove the RH quarter side impact hardware.







3. Remove the two electronic door lock control processor nuts.
4. Remove the electronic door lock control processor through the access hole.







5. Disconnect the electronic door lock control processor electrical connector.
6. Disconnect the electronic door lock control processor antenna.
7. Remove the electronic door lock control processor from the vehicle.

INSTALLATION
To install, reverse the removal procedure.

Tighten the electronic door lock control processor nuts to 6 Nm (5 Lb-Ft).