Starter Relay: Service and Repair

REMOVAL






1. Disconnect the battery ground cable.
2. Remove the starter relay terminal cover.
3. Remove the two terminal starter motor solenoid relay switch nuts.
4. Pull off the push-on connector.
5. Remove the wiring assemblies from the starter motor solenoid relay switch terminals.

NOTE: To aid installation, note wire assembly orientation.

6. Remove the two starter motor solenoid relay switch-to-inner fender screws and the starter motor solenoid relay switch.

INSTALLATION
1. To install, reverse the removal procedures.
2. Tighten the starter motor solenoid relay switch-to-inner fender screws to 11-13 Nm (98-115 Lb-In).
3. Tighten the starter motor solenoid relay switch terminal nuts to 7-9 Nm (62-79 Lb-In).