Disassembly

Main Control Valve Body Assembly, (Part 1 Of 2):

Main Control Valve Body Assembly, (Part 2 Of 2):

DISASSEMBLY






1. Place main control valve body on bench with valve body separator plate up, and remove two torx bolts retaining valve body separator plate to main control valve body.
2. Remove and discard separator plate with bonded gasket.

Valve Body Check Balls, Relief Valves, And Filter:

3. Remove six check balls, two relief valves and two filters. Clean filters.
4. The individual valves and springs are removed by removing retaining clips and bore plugs. Refer to the diagrams and component locations for valve and spring locations.

CAUTION: Most valves are aluminum and cannot be removed using a magnet. Remove valves by tapping valve body on palm of hand to slide valves out of bores. It may be necessary to remove valves and springs using a pick. If it is necessary to use a pick, use extreme caution to prevent damaging valves or valve bores.

5. Clean valves, springs and main control valve body under Cleaning and Inspection.