Integrated Control Relay Module: Service and Repair

Removal

1. Raise vehicle.
2. Loosen screw securing electrical connector to [1][2]constant control relay module and disconnect electrical connector.
3. Remove upper screw retaining [1][2]constant control relay module.
4. Lift [1][2]constant control relay module up and rearward to pull corner of module out of retaining slot.

Installation






1. Position [1][2]constant control relay module and install upper retaining screw.
Do not tighten screw at this time.
2. Tighten bolt to 2.1-2.9 Nm (19-26 inch lbs.).
3. Connect electrical connector to [1][2]constant control relay module and tighten bolt to 1.4-2.0 Nm (12-18 inch lbs.).
4. Lower vehicle.