Power Window Motor: Service and Repair

Heavy Duty Riverter:

Special Tool(s)

REMOVAL
1. Disconnect the battery ground cable.







2. Remove the door handle bezel.







3. Remove the power window/door lock switch bezel, if so equipped.







4. Remove the rearview mirror fastener trim cover.







5. Remove the door panel trim retaining screws.
6. Lift the door trim panel up from the door to disengage the trim panel clips.
7. Remove the courtesy lamp wiring harness connector and remove the door trim panel.







8. Disconnect the electrical connector.







9. Remove the center pins from the rivets, using a drift. Using a 1/4-inch diameter drill, drill out the rivets attaching the window regulator electric drive bracket to the inner panel.

NOTE: Use care not to enlarge the sheet metal holes in the door inner panel.

10. Working through the access hole, remove the window regulator electric drive bracket from the inner panel.
- Rotate to gain access to the three screws retaining the window regulator electric drive to the bracket and cable drum housing.
11. Remove the screws, and separate the window regulator electric drive from the bracket and cable drum.
12. Remove the window regulator electric drive.

INSTALLATION
1. Follow the removal procedure in reverse order.
- Use the Heavy Duty Riveter to install the rivets (W525172-S).