Cylinder Head Assembly
GENERAL SPECIFICATIONSCombustion Chamber Volume: 52±0.5 cm
Head Gasket Surface Finish: (a)
a Head Gasket Surface-WT = 10.0/2.5. Head Gasket Surface Finish-RZU-13.5 microns. Filter Cut off at 0.08 mm, TPI @ 3.5 microns below the peak 63% min. cutoff at 0.8 mm, 0 Ref = 2V.
TORQUE SPECIFICATIONS
Tighten the bolts in three stages, in the sequence shown.
- Cylinder head bolts must be replaced with new bolts. They are tighten-to-yield designed and cannot be reused.
- LH is shown. RH is similar.
Stage 1: 37-43 Nm (27-32 ft. lbs.)
Stage 2: Rotate 85-95 degrees
Stage 3: Rotate 85-95 degrees