Ignition Switch: Service and Repair

For an exploded view of the Steering Column, refer to Steering and Suspension / Steering / Steering Column / Diagrams / Exploded Views.

REMOVAL
1. Disconnect the battery ground cable.





2. Release the four (A) four clips and remove the (B) steering column opening cover.





3. Release the three (A) clips and remove the (B) lower instrument panel steering column cover.





4. Position the hood latch release handle aside.
(1) Remove the two screws.
(2) Position the hood latch release handle aside.





5. Position the parking brake release handle aside.
(1) Remove the two screws.
(2) Position the parking brake release handle aside.





6. Remove the instrument panel floor duct panel.
- Remove the two push clips and release one expander clip.





7. Remove the upper instrument panel steering column cover.
(1) Remove the six bolts.
(2) Remove the upper instrument panel steering column cover.





8. Disconnect the ignition switch electrical connector.
(1) Remove the electrical connector bolt.
(2) Disconnect the electrical connector.





9. Remove the ignition switch.
(1) Remove the two screws.
(2) Remove the ignition switch.

For further service procedures of the Cylinder Lock Housing, please refer to Steering and Suspension / Steering / Steering Column / Service and Repair. Service and Repair


INSTALLATION

















1. To install, reverse the removal procedure.