Crankshaft Position Sensor: Service and Repair

REMOVAL
1. Disconnect battery ground cable.
2. Raise vehicle on hoist.
3. Disconnect fuel charging wiring from the Crankshaft Position sensor (CKP sensor).
4. Remove crankshaft position sensor shield stud bolts and remove crankshaft position sensor from the engine front cover.

INSTALLATION
1. Position crankshaft position sensor and install retaining stud bolts. Tighten stud bolts to 8-12 Nm (71-106 lb-in).

CAUTION: Do not over tighten crankshaft position sensor retaining stud bolts or damage to crankshaft position sensor may occur.

2. Install crankshaft position sensor shield and retaining nuts. Tighten nuts to 2-4 Nm (18-35 lb-in).
3. Properly route fuel charging wiring and connect to crankshaft position sensor.
4. Lower vehicle.
5. Connect battery ground cable.