Ignition Switch: Service and Repair
REMOVAL1. Disconnect battery ground cable.
2. Disconnect the ignition switch electrical connector.
3. Rotate the ignition switch lock cylinder to the RUN position.
4. Remove the two ignition switch screws.
5. Disengage the ignition switch from the actuator
INSTALLATION
NOTE: A new replacement ignition switch assembly will be set in the RUN position as received.
1. Adjust the ignition switch by sliding the carrier to the switch RUN position.
2. Check to make sure that the ignition switch lock cylinder is in the RUN position. The RUN position is achieved by rotating the ignition switch lock cylinder approximately 90 degrees from the LOCK position.
3. Install the ignition switch onto the actuator pin.
NOTE: It may be necessary to move the ignition switch slightly back and forth to align the ignition switch mounting holes with the lock cylinder housing threaded holes.
4. Install the ignition switch screws. Tighten to 6-10 Nm (54-88 inch lbs.).
5. Connect the ignition switch electrical connector.
6. Connect battery ground cable.
7. Check ignition switch for proper function including START and ACC positions. Also, make certain that the column is locked in the LOCK position.