Removal

NOTE: Ford does not provide a TDC (Top Dead Center) mark or determination procedure for this engine in this vehicle.
ALLDATA users have reported success using aftermarket tools to determine TDC on this engine.

1. Disconnect battery ground cable.
2. Drain engine cooling system.
3. Drain crankcase.
4. Remove crankshaft pulley and damper.
5. Remove engine front cover.
6. Rotate crankshaft until No.1 piston is at Top Dead Center (TDC) and the timing marks are aligned as illustrated.
7. Remove camshaft sprocket retaining bolt and washer.
8. Check timing chain deflection for excessive wear.
9. Slide camshaft sprocket, crankshaft sprocket and timing chain forward and remove as an assembly.

Fig. 8 Timing Chain Alignment:

10. Clean engine front cover and oil pan sealing surfaces of all gasket material and silicone sealer.