Power Window Motor: Service and Repair

REMOVAL
1. Raise the front door window glass to the full up position.
2. Remove the front door trim panel.
3. Peel back the front door watershield.
4. To access the power window motor bolts, use a 3/4-inch hole saw with a 1/4-inch pilot to drill two holes at the existing drill dimples on the door.

NOTE: Make sure the electrical connector is not in the way before drilling.







5. Remove the power window motor.
1 Remove the bolts.
2 Disconnect the electrical connector.
3 Remove the power window motor.

NOTE: Prior to motor removal, make sure the regulator arms are in a fixed position to prevent counterbalance spring unwind.

INSTALLATION






1. To install, reverse the removal procedure.
- Cycle the door glass to make sure the gears engage.