Rear

Rear Brake Anti-Lock Sensor Routing, Part 1 Of 2:

Rear Brake Anti-Lock Sensor Routing, Part 2 Of 2:

Rear Brake Anti-Lock Sensor, Part 1 Of 2:

Rear Brake Anti-Lock Sensor, Part 2 Of 2:

Removal
1. Raise vehicle on hoist.





2. Disconnect rear brake anti-lock sensor from the mating body connector located under the vehicle in the center on No. 4 crossmember as shown.
3. Disconnect routing clips from rear suspension arm and bushing and No. 4 crossmember torque box.
4. On station wagon, remove retaining bolt and rear brake anti-lock sensor from rear disc brake adapter on sedan and from rear wheel spindle.


Installation
1. Insert rear brake anti-lock sensor into hole in rear disc brake adapter on sedan, and into hole in rear wheel spindle on station wagon. Install retaining bolt. Tighten to 7.6 - 10.4 Nm (68 - 92 inch lbs.).
2. Install sensor routing clips to rear suspension arm and bushing and No. 4 crossmember torque box.





3. Connect rear brake anti-lock sensor to mating body connector as shown.
4. Lower vehicle.