Planet Assembly

Special Tools:

Disassembly








1. Remove retaining ring.





2. Remove front planet. Clean and inspect for looseness and discoloration of pinion gears or wear on bearings. Service as required.





3. Remove No. 13 thrust bearing.





4. Remove rear planet from shell and rear ring gear assembly.





5. Clean rear planet and inspect for looseness and/or discoloration of planet gears or wear on bushings or bearings. Service as required.

Assembly





1. Install rear planet into rear ring gear.





2. Install No. 13 thrust bearing to rear ring gear with black side of bearing facing up.





3. Install front planet into rear ring gear.





4. Install retaining ring to rear ring gear.





5. Install the reverse clutch assembly over the front planet.





6. Make sure the reverse clutch assembly is fully seated





7. Install Remover/Replacer Tube T75L-7025-C and Reverse Clutch/Planet Assembly Collet T94P-77001-FH over front planet and into rear clutch assembly.





8. Install Bearing Collet Sleeve T77F-7025-C. This assembly is now ready for re-assembly in case later.