Steering Column Sensor Ring

Removal

CAUTION: The steering column must be in the locked position, or the lower end of the column wired in such a way that the steering column does not rotate, resulting in damage to the air bag sliding contact.

Note: Discard the upper intermediate shaft to steering column shaft bolt upon removal. Do not reuse; install a new bolt.





1. Remove the upper intermediate steering shaft to column shaft bolt.
1 Remove and discard the steering column shaft pinch bolt.
2 Slide the intermediate shaft yoke from the steering column.





2. Remove the shock absorber electronic steering sensor.
1 Disconnect the electrical connector.
2 Remove the screws.
3 Remove the shock absorber electronic steering sensor.





3. Remove the sensor ring.
1 Remove the steering column lower bearing spring.
2 Remove the sensor ring.

Installation
1. Follow the removal procedure in reverse order.





2. Install the shock absorber electronic steering sensor.
1 Position the shock absorber electronic steering sensor.
2 Install the screws.
3 Connect the electrical connector.





3. Use a new pinch bolt.