Transmission Mount: Service and Repair

Removal

1. Note: 4x2 procedure shown. 4x4 similar, front drive shaft will need to be removed.

Disconnect the battery ground cable.
2. Raise and support the vehicle.





3. Note: To maintain initial driveshaft balance, mark the rear driveshaft yoke and axle flange so they may be installed in their original alignment.

Mark the rear driveshaft.





4. Remove the rear driveshaft.
1. Remove the bolts.
2. Remove the rear driveshaft.





5. Remove the transmission mount nuts.





6. Raise and support the transmission.





7. Remove the transmission mount.
1. Remove the screws.
2. Remove the transmission mount.

Installation





1. Install the transmission mount.
1. Position the transmission mount on the extension housing.
2. Install the transmission mount-to-extension housing screws.





2. Install the transmission mount into the crossmember and tighten the nuts.





3. Note: Align the driveshaft with the marks made during removal to ensure correct balance.

Align and install the rear driveshaft.





4. Install the bolts.
5. Lower the vehicle.
6. Connect the battery ground cable.