Seat Memory Set Switch

Remove the memory set switch. Measure the resistance between the indicated terminals while pressing the requested switches.







The resistance should be less than 5 ohms for each switch position.

If the resistance is not less than 5 ohms for each switch, replace the switch; otherwise, return to the calling Pinpoint Test.







To check the memory set switch LED, connect the positive meter lead to terminal 8 and the negative lead to terminal 9. The meter should indicate greater than 0.3 volts. Reversing the leads, the meter should read OL.

If the meter readings are not as indicated above, replace the switch; otherwise, return to the calling Pinpoint Test.