Front Door Window Motor: Service and Repair

REMOVAL
1. Raise the front door window glass to the full up position.
2. Remove the front door trim panel.
3. Position the watershield aside.







4. To access the power window motor bolts, use a 19mm (3/4-in) hole saw with a 8mm (1/4-in) pilot to drill three holes at the existing drill dimples on the door.

CAUTION: Make sure the electrical connector is positioned aside before drilling.







5. Disconnect the front door window regulator electrical connector.







6. Remove the bolts and the front door window regulator motor.

INSTALLATION
1. To install, reverse the removal procedure.
^ Cycle the window glass to make sure the gears engage.