Cruise Control Servo Cable: Service and Repair

REMOVAL







1. Remove the accelerator control splash shield
1 Remove the screws.
2 Remove the accelerator control splash shield.







2. Disconnect the speed control cable from the throttle nail head.
1 Open the throttle valve.
2 Slide the throttle cable to disconnect from the throttle cam nail head.
3 Squeeze the speed control cable tabs and remove from the throttle cable bracket.
3. Remove the speed control cable from the retaining clips.







4. Remove the speed control cable cap from the speed control servo.
1 Put in the locking arm on the speed control cable cap.
2 Rotate the speed control cable cap counter clockwise and remove the speed control cable cap from the speed control servo.







5. Remove the speed control cable.
1 Depress the spring retainer.
2 Slide the core wire end out of the speed control servo pulley and remove the speed control cable.

INSTALLATION







1. Insert the speed control cable slug into the speed control servo pulley slot.
1 Gently compress the speed control servo spring.
2 Insert the speed control cable slug into the speed control servo pulley slot.







2. Release the compressed spring while aligning the speed control cable cap tabs with the slots in the speed control servo housing.

NOTE:
^ Make sure the rubber seal is fully seated onto the speed control cable cap.
^ Incorrect wrapping of the speed control cable around the speed control servo pulley may result in a high idle condition.







3. Rotate the speed control cable cap until the locking arm engages.







4. Install the speed control cable.
1 Open the throttle valve.
2 Install the speed control cable to the throttle cam nail head.
3 Install the speed control cable to the bracket.

NOTE: Make sure that the speed control cable is installed in all cable retainer clips.