General Specifications

Part 1 of 6





Part 2 of 6





Part 3 of 6





Part 4 of 6





Part 5 of 6





Part 6 of 6

a Newly installed-Refers to the condition of the NEW drive belt before the engine has made no more than one rotation and before the belt has had a chance to stretch or seat into the pulley grooves.

b Head Gasket Surface-WT = 10.0/2.5. Head Gasket Surface Finish-RZU-13.5 microns. Filter cut off at 0.08 mm, TPI @ 3.5 microns below the peak 63% min. cutoff at 0.8 mm, 0 Ref=2V.

c Time required for the plunger to leak down 1.6 mm of travel with 222 N force and leak-down fluid in tappet.

d The pin bore and crank bearing bore must be parallel and in the same vertical plane within the specified total difference when measured at the ends of a 203 mm bar, 105.5 mm on each side of rod centerline.