Torque Specifications
Cylinder HeadNOTE: LH shown, RH similar.
Install the 12 mm bolts and tighten in the sequence shown.
Install the two 8 mm bolts.
Tighten the eight 12 mm bolts in the sequence shown in two stages.
^ Stage 1: Tighten the bolts 80 degrees.
^ Stage 2: Tighten the bolts an additional 80 degrees.
LH Camshaft Bearing Cap Bolts
Position the oil supply tube, the camshaft bearing caps, and the bolts.
^ Tighten the bolts in the sequence shown in two stages.
^ Stage 1: Tighten the bolts to 6 Nm (53 inch lbs.).
^ Stage 2: Tighten the bolts to 16 Nm (12 ft. lbs.).
RH Camshaft Bearing Cap Bolts
Position the oil supply tube, the camshaft bearing caps, and the bolts.
^ Tighten the bolts in the sequence shown in two stages:
^ Stage 1: Tighten the bolts to 6 Nm (53 inch lbs.).
^ Stage 2: Tighten the bolts to 16 Nm (12 ft. lbs.).
Camshaft Sprocket Bolt
Tighten bolt to 85 Nm (63 lb-ft).
Intake Manifold
Tighten fasteners to 10 Nm (89 lb-in).
Exhaust Manifold
Tighten fasteners to 22 Nm (16 lb-ft).