Parking Brake Control: Service and Repair
ControlRemoval and Installation
1. NOTE: Verify that the parking brake control is fully released.
Relieve the tension on the parking brake system.
1. Pull down on the parking brake intermediate cable.
2. Insert a 4 mm (5/32-inch) drill bit or equivalent retainer in the parking brake control.
2. Disconnect the front parking brake cable and conduit at the locating hole end of the connector.
3. Remove the front parking brake cable and conduit from the bracket.
1. Compress the retainer from the front parking brake cable and conduit from the bracket.
2. Remove the front parking brake cable and conduit from the bracket.
4. Remove the parking brake release mounting bolts.
5. Remove the parking brake control and front parking brake cable and conduit.
1. Disconnect the parking brake signal switch electrical connector.
2. Remove the three parking brake control bolts.
6. To install, reverse the removal procedure.