Rear Door Window Regulator: Service and Repair

REAR DOOR WINDOW REGULATOR AND MOTOR

Removal and Installation
1. Remove the door mounted speaker.







2. Remove the watershield.
- Disconnect the electrical connector from the door.







3. Connect the window control switch.







4. Lower the window glass and align the retainer with the access hole.







5. NOTE: Some vehicles may use rivets to attach the glass to the regulator.

Remove the bolt or rivet that attaches the glass to the regulator.







6. Raise and support the rear door window glass to the full up position.







7. NOTE: Do not detach the door handle from the latch cable during this step.

Remove the rear inside door handle.
1. Remove the screw.
2. Disengage the inside door handle from the door.







8. If equipped, disconnect the power door lock rod from the back of the inside door handle.







9. Gain access to the power window motor electrical connector located in the front of the door.







10. Disconnect the power window motor electrical connector.
- Press down on the connector tab.
- Pull the connector upward and remove through the speaker opening in the door.







11. Disconnect the rear door window regulator and motor assembly from the door.
- Remove the nuts.
- Remove the screws.







12. Remove the window regulator and motor assembly from the door.
13. To install, reverse the removal procedure.