Ignition Coil: Service and Repair
REMOVAL1. Remove the primary battery fuse cover on RH side.
2. Disconnect the bulkhead-to-upper intake manifold.
3. Disconnect the injection control sensor and the fuel temperature sensor, and position the wiring harness out of the way.
4. Disconnect the Coil On Plug (COP) electrical connectors.
5. Disconnect the eight fuel injector electrical connectors.
6. Remove the bolts and ignition coils.
INSTALLATION
1. To install, reverse the removal procedure.
NOTE: Apply brake caliper grease to the inside of the coil boots.