Front Door Window Glass: Service and Repair
REMOVAL1. Remove the door trim panel.
2. Remove the water shield.
3. Remove the pin-type retainer and the interior weatherstrip.
4. Remove the beltline moulding.
5. Position the door window glass to access the door window regulator clamp bolts.
6. Remove the two door window regulator clamp bolts and sleeve assemblies.
7. Remove the door window glass.
INSTALLATION
1. Position the door window glass into the window regulator clamps.
^ Install the two bolt and sleeve assemblies into the window regulator clamps but do not tighten.
NOTE: The door window glass must be fully seated into the window regulator clamps before the bolt and sleeve assemblies are installed.
2. Remove the No.4 convertible top weatherstrip.
3. Raise the door window glass to the full up position.
NOTE: The door must be closed to carry out this step.
4. Install a 13 mm (0.52 in) wedge between the top of the glass and the convertible top No.4 frame.
5. Tighten the two door window regulator clamp bolts.
6. Remove the 13 mm (0.52 in) wedge.
7. Install the beltline moulding.
8. Install the interior weatherstrip and the pin-type retainer.
9. Install the water shield.
10. Install the door trim panel.
11. Operate the door window glass and check for binding and correct alignment.