Transmission Position Sensor/Switch: Service and Repair
Digital Transmission Range (TR) SensorSpecial Tools:
Special Tool(s)
1. On 4x4 vehicles, remove the front driveshaft.
2. On 4x2 vehicles, with the vehicle in NEUTRAL, position on a hoist.
3. It is not necessary to remove the shift cable and bracket from the transmission.
4. Remove the components in the order indicated in the illustration and table.
5. To install, reverse the removal procedure
6. Refill the transmission with the specified fluid.
7. Verify that the shift cable is adjusted correctly.
Item 1: TR Sensor Electrical Connector Removal Note
1. Move the rubber boot back to gain access to the connector.
2. Disconnect the digital TR sensor connector.
Item 6: TR Sensor Installation Note
1. CAUTION: The digital TR sensor must fit flush against the boss on the case to prevent damage to the sensor.
Install the digital TR sensor and loosely install the screws.
Item 5: TR Sensor Screws Installation Note
1. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.
NOTE: The manual lever must be in the NEUTRAL position.
Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.
Item 1: TR Sensor Electrical Connector Installation Note
1. Connect the digital TR sensor connector.
2. Move the rubber boot back over the connector.