Test G

PINPOINT TEST G: LFC 33 AND 34/DTC B2292 - RESTRAINT SYSTEM SAFETY BELT PRETENSIONER STATUS

Test G1:

Test G2:

Test G3-G4:

Test G5-G7:

Test G7-G9:

Test G10-G11:

Test G12-G13:

Test G14-G16:

Test G17-G18:

Test G18-G19:

Normal Operation
The restraints control module (RCM) checks all of the safety belt pretensioners for faults. If the RCM detects one of the faults on any of the safety belt pretensioner circuits, it will store diagnostic trouble code (DTC) B2292 in memory and flash, depending on the fault indicator, either lamp fault code (LFC) 33 or 34 (or higher priority code if one exists) on the air bag indicator.

Fault Conditions
The RCM monitors for the following fault conditions:
- low resistance.
- circuit open.
- circuit short to voltage.
- circuit short to ground.

Possible Causes
A safety belt pretensioner status fault can be caused by:
- damaged wiring, terminals, or connectors.
- a faulty pretensioner.
- RCM is faulted.