Rear Window Wiper Motor

REAR WINDOW WIPER MOTOR

REMOVAL
1. Disconnect the battery.







2. NOTE: Make sure that the wiper motor is in park position.

Remove the wiper arm.
- Lift up the plastic cap and loosen the nut approximately two turns.
- Lift the wiper arm and release it from the taper by moving it to one side.
- Remove the nut and the wiper arm.







3. Remove the liftgate trim panel.
1 Remove the pull handle covers, screws and handle.
2 Remove the liftgate trim panel bolt covers, screws.







4. Remove the rear wiper motor and mounting plate.
1 Disconnect the wiper motor electrical connector.
2 Remove the ground lead.
- Remove the three bolts.







5. Remove the wiper motor from the bracket.

INSTALLATION

1. NOTE: Make sure that the wiper motor is in the parked position.

To install, reverse the removal procedure.

2. Check operation of wiper.