Crankshaft Position Sensor: Service and Repair
CRANKSHAFT POSITION (CKP) SENSORREMOVAL
1. With the vehicle in NEUTRAL, position it on a hoist.
2. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
3. Remove the bolt and position the ground cable aside.
4. Disconnect the crankshaft position (CKP) sensor electrical connector.
5. Remove the bolt and the CKP sensor.
INSTALLATION
1. NOTE: Apply clean engine oil to the O-ring seal before installation.
To install, reverse the removal procedure.