Transmission Position Sensor/Switch: Service and Repair

Digital Transmission Range (TR) Sensor





Special Tool(s)

1. With the vehicle in NEUTRAL, position it on a hoist.
2. It is not necessary to remove the range selector lever cable and bracket from the transmission.





3. Remove the parts in the order indicated in the above illustration and table.
4. To install, reverse the removal procedure.





Item 1: TR Sensor Electrical Connector Removal Note
1. Move the rubber boot back to gain access to the electrical connector.





2. Disconnect the digital TR sensor electrical connector.





Item 6: TR Sensor Installation Note

1. CAUTION: The digital TR sensor must fit flush against the boss on the case to prevent damage to the sensor.

Install the digital TR sensor and loosely install the screws.





Item 5: TR Sensor Screws Installation Note

1. CAUTION: Tightening one screw before tightening the other may cause the sensor to bind or become damaged.

NOTE: The manual lever must be in the NEUTRAL position.

Using the special tool, align the digital TR sensor and tighten the screws in an alternating sequence.





Item 1: TR Sensor Electrical Connector Installation Note
1. Connect the digital TR sensor electrical connector.





2. Move the rubber boot back over the electrical connector.