Crankshaft, Engine

Main bearing journal diameter 67.482-67.504 mm (2.66-21.661 inch)
Main bearing journal maximum taper 0.004 mm (0.0002 inch)
Main bearing journal maximum out-of-round 0.05 mm (0.002 inch)
Main bearing journal-to-cylinder block clearance-desired 0.025-0.044 mm (0.001-0.002 inch)
Main bearing journal-to-cylinder block clearance-allowable 0.025-0.050 mm (0.00098-0.00197 inch)
Connecting rod journal diameter 52.983-53.003 mm (2.085941-2.086728 inch)
Connecting rod journal maximum taper 0.004 mm (0.0002 inch)
Connecting rod journal maximum out-of-round 0.05 mm (0.002 inch)
Crankshaft maximum end play 0.075-0.377 mm (0.003-0.015 inch)

Crankshaft Main Bearing Cap bolts





Install the vertical main bearing cap fasteners and tighten in the sequence shown.
Tighten to 40 Nm (30 ft. lbs.).
Tighten an additions 85-95 degrees.





Back out the jackscrews against the cylinder block in sequence shown.
Tighten to 5 Nm (44 inch lbs.).
Tighten to 10 Nm (89 inch lbs.).





Install the side bolts 21 Nm (15 ft.lbs.)
Check the crankshaft end play.