Manual

Transfer Case Installation-Manual Transaxle

Material








1. CAUTION: The O-ring must be correctly installed before mating the transfer case to the manual transaxle. Failure to correctly install the O-ring may cause the O-ring to be damaged, resulting in a transaxle fluid leak.

Install a new O-ring seal.
2. Position the transfer case.
3. Install the 2 transfer case-to-transaxle nuts.
^ Tighten to 45 Nm (33 ft. lbs.).
4. Install the 2 transfer case-to-transaxle bolts.
^ Tighten to 45 Nm (33 ft. lbs.).





5. Install the crossmember brace and the 4 bolts.
^ Tighten to 40 Nm (30 ft. lbs.).
6. Install the driveshaft.
7. Fill the transfer case.