Barometric Pressure Sensor: Service and Repair
BAROMETRIC PRESSURE (BARO) SENSORRemoval and Installation
1. CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
Turn the ignition switch to the OFF position.
2. CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab can occur.
Remove the instrument panel steering column cover.
1 Unlock the retainers.
2 Remove the instrument panel steering column cover.
3. Remove the barometric pressure (BARO) sensor.
- Disconnect the BARO sensor electrical connector.
- Release the clip and remove the BARO sensor.
4. To install, reverse the removal procedure.