Caliper Removal and Installation, Front
Removal and InstallationWARNING: Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
CAUTION: Do not allow the brake master cylinder reservoir to run dry during the bleeding operation. Keep the brake master cylinder reservoir filled with the specified brake fluid. Never reuse the brake fluid that has been drained from the hydraulic system.
CAUTION: Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with water.
1. Remove the wheel and tire assembly.
2. Loosen the brake flexible hose.
3. Remove the front brake pads.
4. CAUTION: Cap the brake hose to prevent fluid loss and dirt contamination.
Disconnect the caliper from the brake flexible hose.
5. To install, reverse the removal procedure.
6. Bleed the brake system