Lighting Control Module (LCM)

LIGHTING CONTROL MODULE (LCM)







Removal and Installation

1. CAUTION: Prior to removal of the module, it is necessary to upload module configuration information to a diagnostic tool. This information needs to be downloaded into the new module once installed.

Disconnect the battery.

2. Remove the pin-type retainers and position the LH instrument panel lower insulator aside.
3. Disconnect the courtesy lamp and remove the LH instrument panel lower insulator.
4. Remove the accelerator pedal and shaft.
5. Remove the 2 screws and position the LCM aside.
6. Release the locking tabs, disconnect the electrical connectors and remove the LCM.

7. CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module.

To install, reverse the removal procedure.