Operation CHARM: Car repair manuals for everyone.
Home >> Ford >> 2006 >> Explorer 2WD V8-4.6L VIN 8 >> Repair and Diagnosis >> Brakes and Traction Control >> Antilock Brakes / Traction Control Systems >> ABS Sensor Block >> Service and Repair
Manuals through 2025 now available!

Our trusted friends have launched a new website named LEMON, which has newer manuals. It also contains all the CHARM manuals.

LEMON is the spiritual successor to CHARM, I recommend you try it!

Link: lemon-manuals.la or lemon-manuals.org.ua

(Some people have issue connecting. LEMON is investigating. For now, use Firefox or change your DNS server)

Or, hide this message: temporarily or permanently

ABS Sensor Block: Service and Repair

Stability Control Sensor Cluster

Stability Control Sensor Cluster:





Removal and Installation

NOTE: When installing a new stability control sensor cluster, the anti-lock brake system (ABS) module must be configured (using vehicle as-built data) and calibrated. Follow the diagnostic tool directions for the calibration procedures. For module configuration, refer to Information Bus (Module Configuration).

1. Disconnect the battery ground cable.





2. Remove the pin-type retainer and the driver side floor console finish panel.





3. Remove the 2 bolts, 2 nuts and the LH instrument panel brace.
^ To install, tighten to 9 Nm (80 inch lbs.).





4. Remove the 2 screws and LH heater duct.
5. Disconnect the stability control sensor cluster electrical connector.
6. Remove the stability control sensor cluster electrical harness retainers and position aside.
7. Remove the 2 stability control sensor cluster bracket nuts and the stability control sensor cluster.
^ To install, tighten to 7 Nm (62 inch lbs.).

8. To install, reverse the removal procedure.
pro multis · About Operation CHARM