Alternator: Service and Repair

GENERATOR







Removal and Installation
1. Disconnect the battery.
2. Remove the throttle body.
3. Rotate the front end accessory drive belt tensioner clockwise and position the front end accessory drive belt aside.
4. Remove the 3 harness locators from the generator bracket.
5. Remove the 4 bolts and the generator bracket.
- To install, tighten to 10 Nm (89 lb-in).

6. Loosen the 2 bolts and position the generator aside.
- To install, tighten to 25 Nm (18 lb-ft).

7. Disconnect the generator electrical connector.
8. Position the protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 9 Nm (80 lb-in).

9. Remove the generator.
10. If necessary, remove the nut and the generator pulley.
- To install, tighten to 109 Nm (80 lb-ft).

11. To install, reverse the removal procedure.