Rear Door Window Regulator: Service and Repair
REAR DOOR WINDOW REGULATORPart 1:
Part 2:
Removal and Installation
1. Remove the rear door trim panel.
2. Remove the rear door speaker.
3. Remove the interior moulding.
4. Remove the rear door weather shield.
5. Remove the rear door window glass-to-regulator bolt.
- Position the rear door window glass as necessary to access the rear door window glass-to-regulator bolt.
- To install, tighten to 7 Nm (62 lb-in).
6. Secure the rear door window glass in the full UP position with tape.
7. Remove the inside door handle, but do not disconnect the latch cable.
- Remove the screw.
- Disengage the inside door handle from the door.
8. Disconnect the window regulator motor electrical connector.
9. Remove the 2 window regulator nuts.
- To install, tighten to 10 Nm (89 lb-in).
10. Remove the window regulator assembly.
11. To install, reverse the removal procedure.