Intermediate Shaft Speed Sensor

Intermediate Shaft Speed Sensor

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.





2. Disconnect the intermediate shaft speed sensor electrical connector.





3. Remove the intermediate shaft speed sensor.
1 Remove the intermediate shaft speed sensor screw.
2 Remove the intermediate shaft speed sensor from the transmission.

Installation





1. NOTE: Inspect the intermediate shaft speed sensor O-ring for damage. If damaged, install a new O-ring.

Inspect and lubricate the O-ring with petroleum jelly.
1 Install the intermediate shaft speed sensor into the transmission.
2 Install the intermediate shaft speed sensor screw.
^ Tighten to 10 Nm (89 inch lbs.).





2. Connect the intermediate shaft speed sensor electrical connector.
3. Lower the vehicle.